Toyota Sienna Hybrid Oil Change (2021+)
Follow this guide and you’ll be able to perform your Toyota Sienna Hybrid oil change from home. This is specific to the 2021 and 2022 model years with the 2.5L hybrid powertrain. New for the 2021 model year, Toyota switched to the conventional spin on oil filter which many consider to be a simpler task to change. It is equipped with a skid plate blocking the oil drain plug and oil filter however one large access panel gives easy access to both at the same time. For more Toyota specific guides, visit the Toyota section.
Tools Needed:
- 14mm wrench or socket and ratchet
- Oil filter wrench
- Phillips head screw driver
- Oil drain pan with 5 quart capacity
- A few shop rags
- Drive on ramps to raise the front end
Parts needed:
As an Amazon Associate I earn from qualifying purchases.
- 0W16 Engine oil – 4.8 quart capacity
- Toyota 90915-YZZF1 oil filter or equivalent aftermarket part
2021+ Toyota Sienna Hybrid Oil Change Procedure:
- Warm engine up to operating temperature
- Drive vehicle onto ramps to raise the front end high enough to easily get under it
- Remove the engine oil fill cap and set aside
- Remove the access panel from the skid plate to get to the oil pan drain plug using the Phillips head screw driver
- Place the drain pan under the drain plug and remove using the 14mm socket or wrench
- When oil has fully drained, reinstall and tighten the drain plug
- Remove the oil filter (use the oil filter wrench if needed)
- Lubricate the new oil filter o ring
- Install and tighten new oil filter to block
- Reinstall skid plate access panel
- Fill engine with 4.5 quarts of fresh engine oil and reinstall engine oil fill cap
- Start engine and back vehicle off of ramps
- Be sure vehicle is parked level and check engine oil level on dip stick – adjust if needed
