Nissan Rogue Oil Change (2014+)
Perform your own Nissan Rogue oil change and you can be sure it was done right, while saving money and time compared to taking it to a shop. This guide is specifically for the 2014 and above Nissan Rogue equipped with a 2.5L engine (QR25). To find other Nissan oil change guides, follow this page.
Tools Needed:
- 14mm wrench
- Filter wrench
- Oil fill funnel
- Drain pan with at least 5 qt capacity
- Ramps or a jack with jack stands
- Clean rag
Parts needed:
As an Amazon Associate I earn from qualifying purchases.
2014+ Nissan Rogue Oil Change Procedure:
- Warm engine to operating temp
- Check engine oil on dipstick to verify no issues
- Raise front end by driving up ramps or jacking up the vehicle and securing it with jack stands
- Loosen the oil pan drain plug using the 14mm wrench and let the engine oil drain into the drain pan
- Remove oil filter which is found in engine bay behind passenger side front tire using the oil filter wrench and let it drain into drain pan
- Clean oil drain plug and oil filter mounting surfaces
- Lubricate new oil filter O ring and install To block
- Reinstall and tighten oil drain plug once all old engine oil has drained
- Fill engine with 4.5 quarts of engine oil with oil fill funnel and reinstall oil fill cap
- Lower vehicle off ramps or jack stands using the jack
- Start vehicle to let engine oil pressure build and then shut engine back down
- Check engine oil level when vehicle is on level ground
- If needed, top off with fresh engine oil until dip stick reads Full
This article is specific to the 2014, 2015, 2016, 2017, 2018, 2019, 2020, and 2021 Nissan Rogue model years equipped with the 2.5L engine.